Balled and Burlap

Many trees, shrubs and evergreens have the root ball wrapped in burlap and secured with string or rope. Large sizes have the ball contained in a wire basket. These must be planted just the way they are, burlap, rope and wire basket too. Fill around the ball with a good soil mix to three-quarters and water thoroughly.

THEN – untie all string or rope from the trunk or stems. Fold back burlap and ropes and tuck down out of sight. If there is a wire basket, fold back the loops and push down, leaving the wire basket on. Add more good soil mix to fill the hole. Water again using a root-stimulating transplant fertilizer.

Size of planting hole

It is vital to dig your planting hole at least 5” larger than the root ball on all sides to allow for soil enrichments before planting. When planting large heavy balls, the soil at the bottom of the hole should be left solid to prevent the tree from settling lower (see illustration). The finished level of the tree should be the same as it was grown, or up to 3” (8 cm) higher.

Fibre Pots

We can not over stress the importance of leaving the pot ON! These pots are made of paper and will rot away in the soil, and are readily penetrated by healthy plant roots. Break off the pot rim down to the soil level. Make three cuts halfway up from the bottom. DO NOT remove the bottom of the pot. Fill in around the pot with a good soil mix. Water thoroughly with a root stimulating transplant fertilizer.

Plastic Pots

Water thoroughly before removing the container. If a light tapping on sides and bottom does not release the soil, make two cuts the length of the pot on opposite sides and gently pull away the halves. Use your fingers or a knife to gently loosen and spread exposed roots that appear crowded. To free the very matted or circling roots, make several vertical cuts 1/2 to 1 inch deep through the root mass.

Perennials and annuals

These are usually grown in beds where 3″ to 6” sphagnum peat moss is spread over the surface and worked into the soil to a depth of 3” to 12”. A good general purpose flowering fertilizer can be added at this time.Thorough bed preparation is important for healthy perennials since they will be growing in that same location for many years to come. If a specimen is being planted or being added to an existing bed, then prepare the planting hole as you would for a tree or shrub.

Special Care for Special Plants

Roses may be in fibre or plastic pots. Most roses are grafted on to different root stock. For reasons of hardiness, the grafted area (which will be the swollen area where the stems originate) must be planted 2 inches below the soil. For Rhododendrons, Azaleas and other Broadleafed Evergreens increase the amount of sphagnum peat moss used by half. Peaches, nectarines and cherries demand excellent fast drainage. DO NOT plant in wet areas. DO NOT overwater.

WHEN PLANTING IS COMPLETED

Watering

Plants grown in plastic pots tend to dry out more quickly, therefore, more frequent watering may be necessary to avoid plant wilt. It takes several weeks for roots to extend beyond the original soil ball, so be sure to check this area as it often dries out faster than surrounding garden soil. Deep watering encourages a deep root system and your plant will become more drought tolerant.

Mulching

Apart from their good appearance and the retarding of weed growth, mulches help to retain moisture. Mulch also keeps roots cool in summer and insulated in winter. Maintenance is easier and your plants will thrive.

THREE EASY STEPS TO SUCCESS

1. Plant the tree or shrub no deeper than it grew at the nursery.

2. It is necessary to plant trees and evergreens in a soil that offers good drainage. Therefore, if you are planting in an area with heavy clay soil, you must make certain modifications before planting.

3. It is vital to dig your planting hole at least 5” larger than the root ball on all sides to allow for soil enrichments before planting.

If you require any further assistance or advice, our professional staff will gladly assist you.